RE: [aus-dotnet] TotalMilliseconds

[Coral Johnson]

I would have agreed up to this point.  But in this case we are receiving
data thru a serial connection, and graphing it.  We have no trouble
receiving it and graphing it, but it is not smooth due to the rounding of
the milliseconds.

-----Original Message-----
From: dotnet-owner@xxxxxxxxxxx [mailto:dotnet-owner@xxxxxxxxxxx]On
Behalf Of Pickering, Mark J
Sent: Friday, 3 December 2004 3:56 PM
To: 'dotnet@xxxxxxxxxxx'
Subject: RE: [aus-dotnet] TotalMilliseconds



I would have thought that was beyond high level software, and was more in
the realm of an embedded system??

Cheers,
Mark

-----Original Message-----
From: dotnet-owner@xxxxxxxxxxx [mailto:dotnet-owner@xxxxxxxxxxx] On Behalf
Of Coral Johnson
Sent: Friday, 3 December 2004 3:50 PM
To: Aus-Dotnet
Subject: [aus-dotnet] TotalMilliseconds

It would seem that TotalMilliseconds has an approximate resolution of 10
milliseconds.  However we need to record times accurate to 1 millisecond.
What is the best way of accomplishing this?

Regards
Coral Johnson
___________________________________________

NetLogica Pty Ltd
107 Scott St Westcourt QLD 4870, Australia
Tel 07 4041 1431
Mobile 0412 706 675
Email coral.johnson@xxxxxxxxxxxxxxxx

_________________
You are a part of the Australian "dotnet" mailing list.
To unsubscribe send "unsubscribe dotnet" or to re-subscribe send "subscribe
dotnet Your Name" in the body of the email to: imailsrv@xxxxxxxxxxx
List managed by: http://www.stanski.com
_________________
You are a part of the Australian "dotnet" mailing list.
To unsubscribe send "unsubscribe dotnet" or to re-subscribe send "subscribe
dotnet Your Name" in the body of the email to: imailsrv@xxxxxxxxxxx
List managed by: http://www.stanski.com

_________________
You are a part of the Australian "dotnet" mailing list.
To unsubscribe send "unsubscribe dotnet" or to re-subscribe send "subscribe dotnet Your Name" in the body of the email to: imailsrv@xxxxxxxxxxx
List managed by: http://www.stanski.com